Hi there iv bought i rossi chip came with instructions today im gonna fit chip tomoro it says set the by-passes screws to 2.5 front and 2- 1.5 rear and co trimmers were about are these screws located. iv read on or two posts that dosent say anything about these screws just trimmers could do with some advice :eatcorn
Joined Oct 2010
1K Posts | 0+
West Yorks
Look at second picture of ecu (in link http://rsvzone.com/forums/showthread...ght=rossi+chip ) with top removed. 2 Blue box things in bottom right corner. That's them.
Rob
them blue ones are co trimmers i no were they are now. just gonna have to look to find these by pass screws tomorro. in the instructions i got it says once your bike will nice idle tuned you will be happy about the below 3000rpm range too. Start with basics check TPS zero clean butterflys before and set idle knob fully un-screwd i dont understand that part any advice
once your bike will nice idle tuned you will be happy about the below 3000rpm range too. Start with basics check TPS zero clean butterflys before and set idle knob fully un-screwd i dont understand that part any i dont understand this part can someone explain to me please
ok just i read loads setting them by passes screws to match fuel and air to new chip
iv put chip in the 2 blue screws were already at 12 oclock. and iv put the by passes screws to the way the instructions say started it up sounds fine the idles just a tad to high and cant seem to get any lower with the adjuster. il go out tomoro when rain clears up see wot happens
