This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

engine stalls on clutch and throttle blip

Joined Aug 2012
4 Posts | 0+
hello,
I have a 04 rsv 1000r and i've got a problem with it stalling...

What it does is when I'm in neutral and standing still if i blip the throttle to about 3000rpm and then let go of the throttle, it stalls.
Also, when approaching a traffic light, I pull in the clutch for the last 2-3 secs while stopping (driving very slowly, but still rolling) and then it stalls.
Then I have to restart the engine, and it starts, but I have the feeling that it doesn't always start as fast as it should in those cases.

It doesn't always happen... I think it happens when i've been riding (with no problems at all) and then stop for 5-10 minutes with the engine turned off (like at a gas station) but not sure.

The dash shows that the battery is at around 12V.

Do you guys have any idea what the problem might be?

Thanks.
 
Do you have open cans fitted? If so, have you had it switched to Map2? If not, this could be your problem.
 
It has Arrow full (with header pipes) exhaust
I don't know if it's been switched to map2 cause I just bought the bike, maybe the guy who sold it to me can tell me.

How can I find out?
How can I switch to map2?
 
The only way to know which map you are using is by taking it to a dealer so they can plug the computer into it, and change it for you if necessary.
 
on mine it is on the right hand side under the fuel tank. maybe you have a panel there?
 
×

New Posts