Iam removing the datatool immobilser from my 1999 mille, a bit stuck, removed most of the immobilser wiring and repaired original wiring, however the immoboliser wires join to a pair of blue / grey wires on a black / white connector this is located between the ECU and relays. The blue / grey wire comes from the right hand side of the frame, through the connector then off to one of the relays, after removing black immobilser wiring not sure where the two blue/grey wires coming out of the connector go to, advice would be appreciated.
Joined Jul 2009
659 Posts | 0+
Sauchie near Stirling in Scotland
Sorry m8 i'm not going to give you any advice i just thought i'd say big up for the username best one iv'e seen for ages ,brilliant...............
Best to get a copy of the workshop manual which has the wiring diagram.......search here for your model
http://www.serviceaprilia.com/public/lum/index.asp
http://www.serviceaprilia.com/public/lum/index.asp
Joined Jan 2009
772 Posts | 0+
Co. Durham
When I removed mine I had to join the 2 blue wires that come out of the block, thats for the fuel pump. Try turning the bike on and see if it primes, if not id dare say that needs to be done. Not sure about the other one though matey 
Joined Jan 2009
772 Posts | 0+
Co. Durham
Joined Jan 2009
772 Posts | 0+
Co. Durham
