anyone done this mod to their bike any good points bad points, I work as a tig welder and will do this before I have the fueling set up on the dyno if it is worth it
a few guys did it on Af1 and had positive results i believe.
Think Sabre was eyeing up doing it to his steed as well
Think Sabre was eyeing up doing it to his steed as well
thats the one cheesy I have all that is needed apart from the get up of my arse and do it mode
Joined Jul 2007
919 Posts | 0+
Rutland, Leics, Midlands
when i spoke with mark when i was gonna do it the centre pipe adds midrange roughly 3-5 bhp and the rear link add is top end of about 1-2bhp
this should take out the flat spot aswell which would be seen on the dyno
the only reason i didn't get it done was i picked up a set of arrow race headers which has sim design
this should take out the flat spot aswell which would be seen on the dyno
the only reason i didn't get it done was i picked up a set of arrow race headers which has sim design
there does seem to be a bit of a dead area around 5-6500 rpm, my next question is I have a power comander the non usb one should I sell it on and get one of them garbo chips until I can get a pc3 with usb as the bike will def need set up for the pc not good on new tyres how much does the chip cost
Joined Apr 2008
1K Posts | 0+
Sunny Bournemouth
