clutch slip

jwer · Sep 24, 2009

:horse sorry, i know this issue has been flogged to death, but does anyone who has tried the m6 mod know if one washer is enough, or will two washers be a better bet?!

i have to get it sorted (along with oil seal in water pump) so will be draining all oil, but dont want to put it back together only to have the bastard thing still slipping and have to do it AGAIN! :mad1

cheers!

Dolenc · Sep 24, 2009

Use some sand paper to roughten the plates a bit if they still have any meat left on them. Should do the trick, without any washers.

AREESSMILL · Sep 24, 2009

You wont need to drain the oil if you leave it on the sidestand.

Yeah roughen up the plates and rinse.
if you put 2 washers in it will clutch drag

Brooky · Sep 25, 2009

you can stick 5 m6 washers on and it won't make any difference it doesn't put any extra tension on springs.
you need a washer with ID larger than the post the bolt threads into and with same OD as original washer and they need fitting under original washers.

Miff UK fitted washers with that spec and its worked for him.

Search

Search

clutch slip

jwer

Dolenc

AREESSMILL

Brooky

Similar threads

New Posts