Is this the right shock for a gen1

Aprilia Forum

Help Support Aprilia Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Joined
Jun 16, 2014
Messages
7
Location
dorset
Hi was looking at the bike and I think it has a gen2 tuono shock fitted will this be ok or will I need to change it.
Will it work with the right linkages
 

Attachments

  • IMG_20140617_164619_014.jpg
    IMG_20140617_164619_014.jpg
    48.6 KB
Hi was looking at the bike and I think it has a gen2 tuono shock fitted will this be ok or will I need to change it.
Will it work with the right linkages
Its not off a Gen2.
Looks like the standard Sach shock to me.Pretty sure the Gen2 uses a slightly longer shock than the Gen1.No remote gas can either.
 
Not off a Tuono possible RSV
Gen1 and RSV Mille use the same shock.
Gen1
attachment.php


Gen2
a20791d14098944ed02965_l.JPG
 
This one doesn't have the black adjuster at the top I think it might be gen2 rsv shock
 
This one doesn't have the black adjuster at the top I think it might be gen2 rsv shock
Well if it is from an RSVR it should be fine as long as you have Gen2 link plates.Pretty sure it would be obvious if it aint,...
 
whatever its off it needs a good fookin clean :lol
the V4 uses a sachs with res :dunno
 
This one doesn't have the black adjuster at the top I think it might be gen2 rsv shock
Some of the later bikes used the screw adjuster,...just to confuse matters.The only way to tell for sure is take the shock out and measure it.
According to the manuals;
Gen1-323mm
Gen2-313mm
That is measured centre to centre of the fixing eyes.
 
Thanks I will measure it and have a look at the dogbone bearings aswell.
The whole bike needs a good clean just got it two weeks ago and haven't even really ridden it yet. It needs some tlc but it will be fine in the end.
 

New Posts

Back
Top