- Joined
- Apr 18, 2013
- Messages
- 59
- Location
- Finland
I'll need few turns/ a holed pipe etc. , from near here I've found just hefty weigting parts but not willing to buy them while target to get a light exhaustcan as possible - any suggestion ?
Up to do muffler - where to find thin stainless steel parts ?
Help Support Aprilia Forum:
- Joined
- May 9, 2013
- Messages
- 178
- Location
- East Yorkshire
- Joined
- Apr 18, 2013
- Messages
- 59
- Location
- Finland
View attachment 4758View attachment 4759I did remember that I'd have some used pipes in storage but the holed plain material was a surprise - I've all the materials in ?
But the sizing is a tricky, one pro builder said that the exhaust square should go down somewhere and then back, it's exact the case with current set up, 2 x 2" dp's are going united in collector and down to appx. 1,6 x 2" and then opening to 2 x 2" inch Giannelli-mufflers, if I do the single muffler alike the unionspot with 2 x dp's should be 2 1/2 pipe ( appx. 1,5 x 2") and then opening to giant 3" muffler (same square than 2 x 2" pipes) - could it work ?
But the sizing is a tricky, one pro builder said that the exhaust square should go down somewhere and then back, it's exact the case with current set up, 2 x 2" dp's are going united in collector and down to appx. 1,6 x 2" and then opening to 2 x 2" inch Giannelli-mufflers, if I do the single muffler alike the unionspot with 2 x dp's should be 2 1/2 pipe ( appx. 1,5 x 2") and then opening to giant 3" muffler (same square than 2 x 2" pipes) - could it work ?
Attachments
Last edited:
