Too cut a long story short engine threw a big end , this engine had a STM mechanical slipper clutch , so I put a replacement engine with the standard Aprilia slipper clutch in.
Just wanted too know where the pipes go to on the injectors , I have three pipes all joined to a " Y " piece plastic joint with a one way valve in one pipe.
I realise the long pipe goes too the clutch case at the bottom , but all the brass pipe joints on the injector bodies had red plastic plugs on them ( sealed off because it was a mechanical slipper ), one on the front injector throttle side , and one either side on the back injector.
Any help guys photo's or diagram much appreciated
Eddie
Just wanted too know where the pipes go to on the injectors , I have three pipes all joined to a " Y " piece plastic joint with a one way valve in one pipe.
I realise the long pipe goes too the clutch case at the bottom , but all the brass pipe joints on the injector bodies had red plastic plugs on them ( sealed off because it was a mechanical slipper ), one on the front injector throttle side , and one either side on the back injector.
Any help guys photo's or diagram much appreciated
Eddie
